The NAND-X is the most advanced Xbox 360 NAND programmer available.

High quality protective case.

The NAND-X is a JTag device that lets you read and write to the X360 NAND which is flash memory where system software/kernel/dash information is stored.

Includes all the hardware required to start JTagging

Only for consoles with Manufacturer date before JUL 09, And Dashboard version 7371 or below

• Fast USB 360 NAND Programming
• Rock Solid 60Mhz ARM Controller
• Easy Install System for both NAND and JTAG
• Includes Quick Solder Connection Kit For NAND
• Includes Quick Solder Connection Kit For JTAG Hack (All Version Motherboards)
• Includes Optional Pin Header Connection Kit For NAND
• Includes Optional Pin Header Connection Kit For JTAG Hack (All Version Motherboards)
• Built-in Programmer For Future NAND-X Firmware Upgrades (Windows App Available)
• Designed For Additional Add-ons
• Proven Technology – Based On NAND Pro Design
• 100% Compatible with NAND Pro v2.0e
• Rock Solid Design – Tested by many JTAGER’S
• High Quality & Trusted Xecuter Design
• Complete with ALL cables required including USB
• Multiple NAND & JTAG Connection Kits Sold Separately for Bulk Installers (Will be cheap – like LT Switch)
• Affordable – We Provide You With More For Less !

Includes

• 1. Retail Packaging
• 2. NAND-X Programmer
• 3. NAND-X Pin Header Cable (Can Also Use without Pin Headers As A Wires Only Cable*)
• 4. NAND-X QSB Install Cable
• 5. JTAG NON-XENON Cable
• 6. JTAG XENON Cable
• 7. NAND-X QSB J1D2
• 8. NAND-X QSB J2B1
• 9. JTAG J1F1 QSB (XENON Only)
• 10. JTAG J2D2 QSB (All Motherboards)
• 11. USB Cable

So....

NAND-X Options

If you want to install the NAND-X using the QSB (Quick Solder Board) System then you need parts #4, #7 and #8. You do not need part #3. (RECOMMENDED METHOD)

If you want to install the NAND-X using the Pin Header System then you need part #3. You do not need parts #4, #7 and #8.

JTAG Options

If you have a Xenon motherboard, then for JTAG you need parts #6, #9 and #10. You do not need part #5.

If you have a Non-Xenon motherboard, then for JTAG you need parts #5 and #10. You do not need parts #6 and #9.


*If you want to cut off the pin header connector on Cable #3 then the wire colors are:

J1D2 Header

J1D2.1 = Black
J1D2.2 = Brown
J1D2.3 = Red
J1D2.4 = Orange
J1D2.5 = Yellow

J2B1 Header

J2B1.6 = Green
J2B1.5 = Blue