Xecuter Coolrunner

CLICK HERE FOR INSTALLATION

New rev.b version instock now. We only sell genuine Xecuter and MATRiX products, beware of fake low quality modchips being sold in NZ.





World famous XBOX hardware developers Team Xecuter introduce the Xecuter CoolRunner - The Ultimate CPLD Development Board !

In early September 2011, Xbox scene homebrew gurus Tiros and GliGli announced that there was finally a way to boot unsigned (homebrew) code on Xbox Phat & Slim models regardless of which kernel was installed ! (before now JTAG'ing a console for homebrew was limited to very old versions of console/kernel and thus made them very difficult and expensive to buy)

Naturally a whole range of third party devices have come onto the market which were basically copies of the DIY design that was released by Tiros and GliGli. As usual the whole scene looked to Team Xecuter to see what design they could come up with to make this the most rock solid mod possible and they have done it again with the Xecuter CoolRunner !

The possibilities for homebrew on the Xbox 360 are endless. There have been hundreds of extra features since JTAG'ing became possible - from your own custom dashboards to legally backing up all your games to a huge 1TB hard drive !

FEATURES:

- Works with most Phat and Slim HDMI consoles.
- Unique design - do not confuse with other brands that have copied the public schematics
- Optimized timing for each motherboard version
- Compatible with all Xbox kernel versions
- Easy programming via JTAG
- Power LED
- Reset Cycle LED
- Low Wire Install (7 Wires Slim, 6 Wires Phat)
- Powered by CK3 Lite, CK3 Pro or CK3i for JTAG Programming
- Works perfectly with the world famous Xecuter NAND-X
- Trusted Xecuter Design & Warranty

*Not available for Xenon motherboards, The new Forza 4 Slim package.